I built this off thingieverse HERE, but this is a build log of how I did it.
The maker is Veroboard.com, but I ordered it from amazon.
Prototype Universal Stripboard 4″x 10″ (101x254mm) 4000 hole Epoxy Fiber
I bought two of these and taped them flat side by side. I put a bead of CA down the middle with both boards bent at a 90 degree angle from each other. When I was happy with the bead, I put both of them on a flat surface with the tape facing down. I pressed the boards together for about 30 seconds, then let them site for about 15 minutes. When I got back, I removed the tape and I had one solid board. From there I took a solid core wire.
Pixel Print Ltd
1059 Marine Drive
North Vancouver, BC V7P1S6
Tel: 778-340-3002 Fax: 778-340-3301 Email: info@veroboard.com http://veroboard.com